Tech

June 27, 2012

Auto-GCAS flight tests on DROID UAV declared a success

NASA Dryden’s DROID small unmanned research aircraft executes a hard right climbing turn to avoid crashing into a rocky desert ridge during flight tests of a miniature ground collision avoidance system for small unmanned air vehicles. The DROID – short for Dryden Remotely Operated Integrated Drone – provided good data for project engineers as they flight-validated the collision avoidance software Installed in a smartphone connected to its autopilot that enabled automatic fly-ups or turns when the aircraft neared terrain.

Project officials at NASA’s Dryden Flight Research Center, Edwards, Calif., are hailing the success of recent flights tests of a miniature automatic ground collision avoidance system for small unmanned aircraft, after the smartphone-assisted system repeatedly executed pull-ups or sharp turns of the test aircraft to avoid imminent impact with terrain in its flight path.

During final test flights of the software integrated into an autopilot on the Dryden Remotely Operated Integrated Drone research aircraft in May, the system consistently commanded evasive maneuvers when it sensed the aircraft was getting too close to rocky, mountainous terrain or ridgelines.

The software has been adapted by the project team into an application for a smartphone using the Android operating system linked to a small Piccolo autopilot. The last flight tests were flown with the smartphone containing the developmental software installed in the aircraft.

This graphic depicts how the automatic ground collision avoidance system (Auto-GCAS) software application, tied to a small autopilot, can command the flight controls to alter the flight path of an aircraft when it is facing the imminent threat of a collision with the ground.

“For these last flights, the smartphone aboard the aircraft eliminated the need for the ground control station link to be in constant communications with the aircraft,” said Dryden’s project manager Mark Skoog. “On these flights the system performed very reliably, consistently initiating recoveries close to the last possible moment, even in the face of numerous losses of communications with the ground control station right at the critical point of needing to avoid the colliding with the mountain,” Skoog said.

Several NASA Dryden Remotely Operated Integrated Drone project team members secure the aircraft’s single-piece wing during flight tests of the project’s miniature ground collision avoidance system for small unmanned air vehicles.

The last two flights, conducted at a remote dry lake surrounded by hilly desert terrain northeast of Edwards Air Force Base, Calif., saw the system successfully execute five mountainous terrain collision avoidance fly-ups, five ridge crossings executed with and without the software’s multi-trajectory mode on, and a clockwise and counter-clockwise “patrol” over the valley with the multi-trajectory mode off.

The last flights were not without a few glitches that are often the hallmark of experimental flight testing and software development, ranging from computer cooling issues in the ground control station van, to a non-responsive left actuator on the DROID research aircraft. The latter challenge forced the project team to disassemble the aircraft’s wing, where they discovered wires had separated. Innovative repairs were made in the field requiring a creative use of the minimal resources available, and the aircraft was again ready to fly.

Test objectives of the final flights included phone-on-aircraft testing of the team’s latest software changes for failure mode logic of the collision avoidance system. The project team also collected terrain influences on wind for trajectory prediction, and verified the software’s nuisance evaluation of single-trajectory versus multi-trajectory flight options.

In all, the phone-on-aircraft software changes functioned well, with the software’s multi-trajectory capability providing noticeable nuisance-free flight improvements over its single-trajectory mode.

The flights were conducted within Dryden’s Western Aeronautical Test Range, which is part of the restricted military flight-test ranges over Edwards Air Force Base and Southern California’s high desert.

NASA Dryden’s DROID small unmanned research aircraft executes a hard right climbing turn to avoid a ridgeline during flight tests of a miniature ground collision avoidance system for small unmanned air vehicles.

“Our last flights represent well over a year of hard work by a highly skilled and dedicated team who have made important steps towards the elimination of controlled flight into terrain accidents,” said Jack Ryan, the project’s chief engineer.

The Auto-GCAS/DROID project team will now complete analysis of the flight data and begin the report writing process.

When fully developed and matured, the miniaturized Auto-GCAS technology could have wide applications for potential use in general aviation aircraft, including both manned and remotely and autonomously operated unmanned aircraft systems.

Development and adaptation of the automatic ground-collision avoidance software into a smart phone application for unmanned aircraft was sponsored by NASA Dryden and the Defense Safety Oversight Council of the U.S. Department of Defense.

Banking hard to starboard after a very close pass near a ridgeline, NASA Dryden’s DROID research aircraft provided good data for project engineers during flight tests of a miniature ground collision avoidance system for small unmanned air vehicles.




All of this week's top headlines to your email every Friday.


 
 

 
nasa-global-hawk

Global Hawk 872 return marks 100th NASA flight

  NASA Global Hawk No. 872 is pictured on the ramp after landing at NASA’s Wallops Flight Facility, Va., at sunrise following its 10th and final science flight Sept. 28–29 in the agency’s 2014 Hurricane and S...
 
 
NASA photograph by Ken Ulbrich

Two NASA Armstrong technologies recognized by tech transfer consortium

NASA photograph by Ken Ulbrich NASA Armstrong researchers Mike Dandachy, Ricardo Arteaga and Duc Tran (from left) were honored for their technology development work on the Automatic Dependent Surveillance Broadcast, or ADS-B, S...
 
 

ONR features technology for Marines of future

From virtual training to laser weapons, the Office of Naval Research is showcasing a range of technologies at Modern Day Marine exposition Sept. 23-25 that will prepare Marines as they continue to face an increasingly complex security landscape. ONR program officers will be in booth no. 2305 during the event, held at Marine Corps Base...
 

 
University of Alaska-Fairbanks photograph by Chris Larsen

NASA airborne campaigns focus on climate impacts in Arctic

University of Alaska-Fairbanks photograph by Chris Larsen Changes in more than 130 Alaskan glaciers are being surveyed by scientists at the University of Alaska-Fairbanks in a DHC-3 Otter as part of NASA’s multi-year Oper...
 
 
NASA/SSAI photograph by Edward Winstead

ACCESS II confirms jet biofuel burns cleaner

NASA/ORAU photograph by Richard Moore NASA’s DC-8 research aircraft leads one of the ACCESS II sampler aircraft across the early morning California sky.   Flying high above the California desert, NASA researchers rec...
 
 

Sparks fly as NASA pushes limits of 3-D printing technology

NASA has successfully tested the most complex rocket engine parts ever designed by the agency and printed with additive manufacturing, or 3-D printing, on a test stand at NASA’s Marshall Space Flight Center in Huntsville, Ala. NASA engineers pushed the limits of technology by designing a rocket engine injector – a highly complex part that...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>