Business

September 19, 2012

Pratt & Whitney selected for funding for U.S. Air Force AETD program

Pratt & Whitney, a unit of United Technologies Corp., has been selected for funding by the Air Force Research Laboratory for the Adaptive Engine Technology Development program.

The AETD program is an initiative by the AFRL Propulsion Directorate to mature critical fuel-burn reduction technologies and engine design features that could transition into legacy and next generation military fighter aircraft.

“Pratt & Whitney is pleased to have been selected to participate in the AETD program and we look forward to delivering a solution that helps lower fuel costs, and increases operational capability for the warfighter,” said Bennett Croswell, president, Pratt & Whitney Military Engines. “By merging innovative adaptive engine and next generation technologies with the best features of our proven F119 and F135 engines, we aim to reduce fuel burn up to 25 percent more than the current generation of fighter engines.”

The AETD program will lead to demonstration testing of an advanced high operating pressure ratio core in late 2015, to be followed in 2016 by full engine testing of a three-stream adaptive fan and three-stream compatible augmentor and exhaust system. The introduction of the third flow path stream will allow the engine operating conditions and resultant bypass ratio to be modulated to optimize performance across all power settings and flight conditions. This will significantly reduce total mission-weighted fuel burn.

“We’re confident that our technical approach will ultimately give future combat aircraft added range and payload capabilities, while reducing the cost burden of expensive jet fuel,” added Croswell. “From an operational perspective, our end goal is to provide pilots more flexibility in accomplishing the mission.”

 




All of this week's top headlines to your email every Friday.


 
 

 
boeing-chinook

Boeing delivers first U.S. Army multiyear II configured Chinook

Boeing July 29 delivered the first multiyear II configured CH-47F Chinook helicopter to the U.S. Army one month ahead of schedule. The delivery was celebrated in a ceremony at the production facility in Ridley Township, Penn. â...
 
 
Army photograph by SSgt. Angela Stafford

Engineers developing safer, more accurate tracer round

Army photograph Tracer rounds enable the shooter to follow the projectile trajectory to make aiming corrections. However, the light emitted by these rounds also gives away the position of the shooter. Engineers at Picatinny Ars...
 
 

General Dynamics to continue work on U.S. Air Force GPS III program

General Dynamics Advanced Information Systems, a business unit of General Dynamics, has been awarded a $25.4 million full-production contract from Lockheed Martin to support the U.S. Air Force Global Positioning System (GPS) III Network Communications Element for space vehicles seven and eight. The Air Force’s next-generation GPS III satellites will improve position, navigation and timing...
 

 

Javelin joint venture demonstrates vehicle-mounted missile launch

The Raytheon and Lockheed Martin Javelin Joint Venture recently fired a Javelin missile from a remote weapon station integrated onto a wheeled vehicle at Redstone Arsenal in Huntsville, Ala. The test demonstrated Javelin’s vehicle-launch capability to an international customer that has expressed interest in purchasing vehicles integrated with Javelin. The Javelin missile launched successfully...
 
 

Royal Australian Air Force scores direct hit with JSOW C

The Royal Australian Air Force has successfully tested a Raytheon Joint Standoff Weapon C against a hardened wall target at the RAAF Woomera Test Range. Launched from an F/A-18F Super Hornet at an operationally representative stand-off range and altitude of 25,000 feet, the JSOW C scored a direct hit. The RAAF test marked the third...
 
 

Boeing to assemble 787-10 Dreamliner in South Carolina

Boeing announced July 30 that final assembly of the 787-10, the newest and longest member of the 787 Dreamliner family of airplanes, will take place exclusively in North Charleston, S.C. Boeing will continue to assemble both 787-8s and 787-9s in Everett, Wash., and North Charleston. Design of the 787-10 is underway in Everett, with final...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>