Defense

November 7, 2012

Upgraded Apache helicopter OK’d for production

Army photograph
The Apache Block III helicopter, unveiled in October 2011, has been re-designated the E model. The Apache Project Office announced the name change during an Oct. 24, 2012, press conference in Washington, D.C.

The Defense Acquisition Board decision regarding full-rate production for the Apache Block III helicopter program was announced Oct. 24, by Army officials at a briefing in Washington, D.C.

Additionally, Apache project manager Col. Jeffrey Hager confirmed that the Apache Block III is being re-designated as an AH-64E model.

The announcement event was attended by 20 media members representing national and industry related publications.

According to the Apache Project Office, the Defense Acquisition Board, or DAB, granted approval for full-rate production, or FRP, in August and the Air Force communicated the model designation change in a September memo to the Army. Actions are under way to begin implementation of the E model designation for subsequent use by the military and industry.

“The DAB’s decision really secured Apache production for the next several years,” Hager said. “We’ve got fiscal requirements, but securing that production through a full-rate production decision was just huge for this program. It’s probably the single largest decision that we’ve had since Block I’s and Block II’s went into production. It’s that monumental.”

One of the other key components, Hager said, that resulted in the DAB decision is the fact that the Block III had been designated an ACAT C program.

“We’re no longer a D program and therefore don’t need DOD oversight. Our Army acquisition executive, Ms. Heidi Shyu, is in charge of the Apache program and the development production that we have for Block III as we go forward from this point. So that was a big designation for us,” Hager said.

The designation of the E model, he added, accurately recognizes the aircraft’s advancements including an Improved Drive System, increased engine capabilities, technologically advanced composite main rotor blades and sensor enhancements.

“At the end of the day, the only real measure of how well a system is performing falls to the user and how easy or difficult the aircraft is to maintain,” said Col. John Lynch, Attack/Reconnaissance TRADOC capabilities manager. “Basically, the Block III exceeded expectations that were laid out on the sustainment side.”

Upgrades to the aircraft over previous models include advanced rotor blades and significantly increased aircraft handling, performance and agility at higher altitudes. Situational awareness is enhanced with electro-optical and infrared sensors for the operational benefit of aviators and battlefield commanders.

“The Apache fleet continues to do very well in Afghanistan and Kuwait,” Lynch said. “It’s has maintained an over 80 percent readiness rate while averaging more than 60 flight hours per month. We’re almost at one million combat flight hours with the Apache.”

First delivered in October 2011, Apache Block III helicopters are in production at the Boeing Company in Mesa, Ariz. Fielding of the AH-64E will occur over the next decade.




All of this week's top headlines to your email every Friday.


 
 

 

Headlines September 2, 2014

News: Debris yields clues that pilot never ejected - When investigators were finally able to safely enter the crash site of an F-15C “Eagle” fighter jet on the afternoon of Aug. 27, they made a grim discovery that concluded more than 30 hours of searching – the pilot never managed to eject from the aircraft.  ...
 
 

News Briefs September 2, 2014

Pentagon: Iraq operations cost $560 million so far U.S. military operations in Iraq, including airstrikes and surveillance flights, have cost about $560 million since mid-June, the Pentagon said Aug. 29. Rear Adm. John Kirby, the Pentagon press secretary, said the average daily cost has been $7.5 million. He said it began at a much lower...
 
 

Unmanned aircraft partnership reaches major milestone

A team of research students and staff from Warsaw University of Technology have successfully demonstrated the first phase of flight test and integration of unmanned aircraft platforms with an autonomous mission control system. The demonstration marks a significant milestone in a partnership between the university and Lockheed Martin that began earlier this year. This is...
 

 

Raytheon delivers first Block 2 Rolling Airframe Missiles to US Navy

Raytheon delivered the first Block 2 variant of its Rolling Airframe Missile system to the U.S. Navy as part of the company’s 2012 Low Rate Initial Production contract. RAM Block 2 is a significant performance upgrade featuring enhanced kinematics, an evolved radio frequency receiver, and an improved control system. “As today’s threats continue to evolve,...
 
 
Courtesy photograph

Two Vietnam War Soldiers, one from Civil War to receive Medal of Honor

U.S. Army graphic Retired Command Sgt. Maj. Bennie G. Adkins and former Spc. 4 Donald P. Sloat will receive the Medal of Honor for actions in Vietnam. The White House announced Aug. 26 that Retired Command Sgt. Maj. Bennie G. A...
 
 

Sparks fly as NASA pushes limits of 3-D printing technology

NASA has successfully tested the most complex rocket engine parts ever designed by the agency and printed with additive manufacturing, or 3-D printing, on a test stand at NASA’s Marshall Space Flight Center in Huntsville, Ala. NASA engineers pushed the limits of technology by designing a rocket engine injector – a highly complex part that...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>