Business

February 13, 2013

Mars Science Lab drills to get rock powder sample

Tags:
Raphael Jaffe
staff writer

At the center of this image from NASA’s Curiosity rover is the hole in a rock called “John Klein” where the rover conducted its first sample drilling on Mars.

Curiosity has now successfully used all of its unique equipment to examine if Mars was capable of supporting microscopic life.

The percussion drill was used to bore into fine-grained sedimentary bedrock on Sol 182 of the mission [Feb 8].

The hole is about 0.63 inch (1.6 centimeters) wide and 2.5 inches (6.4 centimeters) deep. The rock powder travels up flutes on the bit, and enters the sample handling mechanism of the Curiosity.

This is the first time any robot has drilled into a rock to collect a sample on Mars. Scientist hope that rocks like this hold evidence about long-gone wet environments. In pursuit of that evidence, the rover will use its laboratory instruments to analyze the rock powder.

The Curiosity controllers at Jet Propulsion Lab cautiously used several days to tap the outcrop, and drill a shallow test hole, which can be seen in the photo below, along with the final hole. The actual drilling took about seven minutes.

ìWe believe we have collected sufficient material from the rock to meet our objectives of hardware cleaning and sample drop-off,” said Avi Okon, cognizant drill engineer at JPL.

Before the rock powder is analyzed, some will be used to scour traces of material that may have been deposited onto the hardware while the rover was still on Earth, despite thorough cleaning before launch. Also, there is some concern that microscopic chips of Teflon may have rubbed off the drill and mixed with the rock powder. Okon said that any Teflon contamination would be small, because of the short drilling time.

We’ll take the powder we acquired and swish it around to scrub the internal surfaces of the drill bit assembly,” said JPL’s Scott McCloskey, drill systems engineer. “Then we’ll use the arm to transfer the powder out of the drill into the scoop, which will be our first chance to see the acquired sample.”

Inside the sample-handling device, the powder will be vibrated once or twice over a sieve that screens out any particles larger than six-thousandths of an inch (150 microns) across. Small portions of the sieved sample will fall through ports on the rover deck into the Chemistry and Mineralogy (CheMin) instrument and the Sample Analysis at Mars (SAM) instrument. These instruments then will begin the much-anticipated detailed analysis.

Building a tool to interact forcefully with unpredictable rocks on Mars required an ambitious development and testing program,” said JPL’s Louise Jandura, chief engineer for Curiosity’s sample system. “To get to the point of making this hole in a rock on Mars, we made eight drills and bored more than 1,200 holes in 20 types of rock on Earth.”

Previous Mars explorers included tools to handle rocks and dirt, but Curiosity is the first to actually drill into the rocks. Opportunity and Spirit have rock grinders. The Phoenix probe to the frozen north pole carried an ice rasp which chiseled frozen soil.

The rock Curiosity drilled is called “John Klein,” in memory of a Mars Science Laboratory deputy project manager who died in 2011. Drilling for a sample is the last new activity for NASA’s Mars Science Laboratory Project, which is using the car-size Curiosity rover to investigate whether an area within Mars’ Gale Crater has ever offered an environment favorable for life.

ìThe most advanced planetary robot ever designed is now a fully operating analytical laboratory on Mars,” said John Grunsfeld, NASA associate administrator for the agency’s Science Mission Directorate. “This is the biggest milestone accomplishment for the Curiosity team since the sky-crane landing last August, another proud day for America.”




All of this week's top headlines to your email every Friday.


 
 

 

President proclaims Memorial Day as ‘Day of Prayer’

President Barack Obama May 22 saluted the service and sacrifices of America’s military members–past and present–and proclaimed Memorial Day, May 25, 2015, “as a day of prayer for permanent peace, and I designate the hour beginning in each locality at 11 a.m. of that day as a time during which people may unite in prayer....
 
 

Air Force leaders’ Memorial Day message

Secretary of the Air Force Deborah Lee James and Air Force Chief of Staff Gen. Mark A. Welsh III send the following Memorial Day message to the Airmen of the Air Force and their families: To the Airmen of the United States Air Force and their Families: On Memorial Day, Americans pause in solemn remembrance...
 
 

Headlines May 22, 2015

News: Second Marine killed in Hawaii Osprey crash identified - Marine Corps officials have identified the second Marine to die as a result of the May 17 MV-22B Osprey crash as Lance Cpl. Matthew J. Determan of Maricopa, Ariz.   Business: Israel defense exports plunge to seven-year low - Israeli defense sales last year plunged to their...
 

 

News Briefs May 22, 2015

Ukrainian officer hit with third charge in Russia A third charge has been filed against a Ukrainian military officer who has been behind bars in Moscow for nearly a year over the deaths of two Russian journalists in Ukraine. Nadezhda Savchenko, who worked as a spotter for Ukrainian troops fighting separatist rebels in eastern Ukraine,...
 
 
Army photograph by C. Todd Lopez

Smart-mortar will help Soldiers more effectively hit targets

Army photograph by C. Todd Lopez Nick Baldwin and Evan Young, researchers with the Armament Research Development and Engineering Center at Picatinny Arsenal, Pennsylvania, discuss the 120mm Guided Enhanced Fragmentation Mortar ...
 
 

Air Force assigns new chief scientist

The Air Force announced the service’s new chief scientist to serve as a science and technology adviser to the secretary of the Air Force and the chief of staff of the Air Force, May 21. Dr. Greg Zacharias will be the 35th chief scientist and is ready to “dive in” to his new role. “I...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>