Defense

June 24, 2013

Navy receives first F-35C Lightning II

Lt. Cmdr. Christopher Tabert, F-35C instructor pilot, prepares to exit the cockpit after landing at Eglin Air Force Base, Fla. The U.S. Navy’s Strike Fighter Squadron (VFA) 101 received the Navy’s first F-35C Lightning II carrier variant aircraft from Lockheed Martin today at the squadron’s home at Eglin Air Force Base, Fla. VFA 101, based at Eglin Air Force Base, will serve as the F-35C Fleet Replacement Squadron, training both aircrew and maintenance personnel to fly and repair the F-35C.

The U.S. Navy’s Strike Fighter Squadron (VFA) 101 received the Navy’s first F-35C Lightning II carrier variant aircraft from Lockheed Martin today at the squadron’s home at Eglin Air Force Base, Fla.

The F-35C is a fifth generation fighter, combining advanced stealth with fighter speed and agility, fully fused sensor information, network-enabled operations and advanced sustainment.

The F-35C will enhance the flexibility, power projection, and strike capabilities of carrier air wings and joint task forces and will complement the capabilities of the F/A-18E/F Super Hornet, which currently serves as the Navy’s premier strike fighter.

By 2025, the Navy’s aircraft carrier-based air wings will consist of a mix of F-35C, F/A-18E/F Super Hornets, EA-18G Growlers electronic attack aircraft, E-2D Hawkeye battle management and control aircraft, Unmanned Carrier Launched Airborne Surveillance and Strike (UCLASS) air vehicles, MH-60R/S helicopters and Carrier Onboard Delivery logistics aircraft.

VFA 101, based at Eglin Air Force Base, will serve as the F-35C Fleet Replacement Squadron, training both aircrew and maintenance personnel to fly and repair the F-35C.

 

Lt. Cmdr. Christopher Tabert, F-35C instructor pilot flying the F-35C breaks away from formation prior to landing. The U.S. Navy’s Strike Fighter Squadron (VFA) 101 received the Navy’s first F-35C Lightning II carrier variant aircraft from Lockheed Martin June 22 at the squadron’s home at Eglin Air Force Base, Fla.




All of this week's top headlines to your email every Friday.


 
 

 

Headlines September 2, 2014

News: Debris yields clues that pilot never ejected - When investigators were finally able to safely enter the crash site of an F-15C “Eagle” fighter jet on the afternoon of Aug. 27, they made a grim discovery that concluded more than 30 hours of searching – the pilot never managed to eject from the aircraft.  ...
 
 

News Briefs September 2, 2014

Pentagon: Iraq operations cost $560 million so far U.S. military operations in Iraq, including airstrikes and surveillance flights, have cost about $560 million since mid-June, the Pentagon said Aug. 29. Rear Adm. John Kirby, the Pentagon press secretary, said the average daily cost has been $7.5 million. He said it began at a much lower...
 
 

Unmanned aircraft partnership reaches major milestone

A team of research students and staff from Warsaw University of Technology have successfully demonstrated the first phase of flight test and integration of unmanned aircraft platforms with an autonomous mission control system. The demonstration marks a significant milestone in a partnership between the university and Lockheed Martin that began earlier this year. This is...
 

 

Raytheon delivers first Block 2 Rolling Airframe Missiles to US Navy

Raytheon delivered the first Block 2 variant of its Rolling Airframe Missile system to the U.S. Navy as part of the company’s 2012 Low Rate Initial Production contract. RAM Block 2 is a significant performance upgrade featuring enhanced kinematics, an evolved radio frequency receiver, and an improved control system. “As today’s threats continue to evolve,...
 
 
Courtesy photograph

Two Vietnam War Soldiers, one from Civil War to receive Medal of Honor

U.S. Army graphic Retired Command Sgt. Maj. Bennie G. Adkins and former Spc. 4 Donald P. Sloat will receive the Medal of Honor for actions in Vietnam. The White House announced Aug. 26 that Retired Command Sgt. Maj. Bennie G. A...
 
 

Sparks fly as NASA pushes limits of 3-D printing technology

NASA has successfully tested the most complex rocket engine parts ever designed by the agency and printed with additive manufacturing, or 3-D printing, on a test stand at NASA’s Marshall Space Flight Center in Huntsville, Ala. NASA engineers pushed the limits of technology by designing a rocket engine injector – a highly complex part that...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>