Business

April 18, 2014

Sikorsky tests CH-53K helicopter for airframe structural strength

sikorsky-test
Sikorsky Aircraft Corp., a subsidiary of United Technologies Corp., has successfully completed an initial series of tests required by the Naval Air Systems Command to verify the structural strength of the CH-53K heavy lift helicopter.

Conducted on a full-size non-flying airframe called the Static Test Article, the tests are part of a three-year program to validate that the largest helicopter ever designed and built by Sikorsky has the structural integrity to operate safely over its entire flight envelope — from its empty gross weight of 44,000 pounds up to its maximum gross weight of 88,000 pounds with external load.

“The Static Test Article will enable Sikorsky to replicate the many stresses, strains and aerodynamic forces the CH-53K helicopter will experience during all aspects of flight, whether the aircraft is empty, filled with cargo, or carrying up to 36,000 pounds of gear suspended beneath the aircraft by an external sling,” said Mike Torok Sikorsky’s CH-53K Program Vice President. “By placing incrementally heavier static loads on various parts of the airframe assembly — including those well beyond the airframe’s analytical design strength — we can measure structural integrity, airworthiness and crash worthiness, and verify safety margins for all expected operational conditions.”

The Static Test Article is housed in a specially-built test facility at Sikorsky’s manufacturing plant in Stratford, Conn. Consisting of the cockpit, the cabin, fuel sponsons, a transition section and the tail rotor pylon, the complete airframe assembly is suspended off the ground by the shaft of its main rotor gearbox. Surrounding support beams hold the numerous hydraulic cylinders that apply the flight and inertial loads to parts of the airframe assembly. Also attached to the STA structure are component-representative weights that simulate the presence of the engines and landing gear, among other key subsystems and components.

To date, Sikorsky has completed a total of six test conditions on the Static Test Article, all conducted during 2013 and early 2014. The first four test conditions satisfy pre-flight requirements ahead of a CH-53K flight test aircraft taking to the skies for the first time later this year. Replicating the maximum load conditions encountered while in flight, the four pre-flight tests measured the structural strength of the tail rotor pylon during high and low speed flight maneuvers, the landing gear during impact with the ground, and the full airframe structure while under maximum rotor power.

Sikorsky will continue to test the structural integrity of the CH-53K Static Test Article for another two years to validate the effects of aerodynamic forces and weight distribution on different sections of the airframe.

The Static Test Article is the first of two non-flying CH-53K test articles — along with five prototype and four production-representative heavy lift helicopters — that Sikorsky is developing as part of a $3.8 billion System Development and Demonstration contract for the U.S. Navy.

Per the current program of record, the Marine intends to order 200 CH-53K production aircraft, and to stand up eight operational squadrons and one training squadron to support the Marine Corps’ operational requirements. Eventual production quantities would be determined year-by-year over the life of the program based on funding allocations set by Congress and the U.S. Department of Defense acquisition priorities.




All of this week's top headlines to your email every Friday.


 
 

 

Northrop, Navy celebrate legacy of EA-6B Prowler

Northrop Grumman photograph by Edgar Mills The U.S. Navy’s last operational EA-6B Prowler, designed and built by Northrop Grumman, lifts off from Naval Air Station Whidbey Island, Wash. in a ceremonial fly-away June 27 from its long time operational base. The Navy is retiring the Prowler after nearly 45 years of service.   The U.S....
 
 

Lockheed signs agreements for two full-flight simulators

Lockheed Martin Commercial Flight Training and Airbus have signed a frame contract enabling Airbus to expedite procurement of flight simulation devices for their customers, Airbus training centers and their affiliates worldwide. The frame contract emphasizes the shared intent to partner on future training programs, and combines Airbus’ and Lockheed Martin Commercial Flight Training’s expert...
 
 

Drone Aviation receives order for U.S. Army aerostat system enhancement

Drone Aviation Holding Corp., a developer of specialized lighter-than-air aerostats and tethered drones, announced June 24 that its wholly owned subsidiary, Drone Aviation Corp., has been awarded an order from U.S. Government prime contractor BAE Systems for parts and services related to enhancing and supporting two WASP aerostat systems owned and operated by the U.S....
 

 

Boeing names Muilenburg as chief executive officer

The Boeing board of directors has elected Dennis A. Muilenburg the company’s 10th chief executive, succeeding W. James (Jim) McNerney, Jr., who held the position for the past 10 years. Muilenburg, who has served as Boeing president and chief operating officer since 2013, becomes president and CEO July 1. McNerney, who joined Boeing’s board of...
 
 
boeing-thailand

Boeing, Thai Airways International celebrate 25th direct 777 delivery

  Boeing and Thai Airways International Public Company Limited celebrated the Thailand flag carrier’s 25th direct 777 delivery, a 777-300ER (Extended Range), from the Boeing delivery center in Everett, Wash.  “...
 
 

General Dynamics receives $219 million for U.S. Army’s WIN-T increment 2 systems

General Dynamics received the first full rate production order from the U.S. Army to build additional Warfighter Information Network – Tactical (WIN-T) Increment 2 systems.  The $219 million order includes the production of more than 300 vehicle-based network communication nodes along with related equipment and materials. WIN-T Increment 2 is the Army’s communications backbone providin...
 




0 Comments


Be the first to comment!


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>